24
DORADO PRO 37MM SERVICE GUIDE
6
4
5
Insert the compression rod, piston first, into the top of
the inner leg using rotational motion.
Use a 22mm crows foot to tighten the air spring end
cap to the proper torque of 1.8-2.8 N m (15-25 in lb).
Replace the oil and dust seals on the outer leg following
the directions on page 26-27. Inspect the inside of
the outer leg, and be sure it is free from debris and
contaminants. Coat the inside of the seal with Slickoleum
grease. Slide the inner leg into the outer leg, and clamp
the top of the outer leg in the bike stand.
Inject 35cc of Manitou Semi Bath oil (5/40wt. Synthetic
oil, P/N: 85-0023) into the outer leg on top of the inner
leg.
SPRING LEG DISASSEMBLY
To Next Page