Manitou DORADO PRO - Page 25

25
DORADO PRO 37MM SERVICE GUIDE
7
8
9
Install the top cap onto the end of the compression rod.
Use a 16 notch Bottom Bracket Tool and a 13mm wrench
to tighten to the proper torque of 3.4-4.5 N m
(30-40 in lb)
Fully extend the inner leg and tighten down the top cap to
the proper torque of 6.8-9.0 N m
(60-80 in lb). Fill the fork to the desired air pressure.
Replace O-ring #100-027 on the top cap.
SPRING LEG DISASSEMBLY