17
DORADO PRO 37MM SERVICE GUIDE
10
Install the top cap onto the end of the rebound shaft.
Use a 16 notch Bottom Bracket Tool and a 12mm
wrench to tighten to the proper torque of 6.8-9.0 N m
(60-80 in lb).
Replace O-ring # 100-027 on the top cap.
Replace the oil and dust seals on the outer leg following the directions on pages 26-27. Inspect the inside of the outer leg and
the outside of the inner leg and be sure they are free from debris and contaminants. Lube the oil seal and dust wiper on the
outer leg with a small amount of Slickoleum grease. Slide the inner leg into the outer leg and clamp into the bike stand.
13
11
12
Install the rebound knob into the top cap by snapping it
into place. Fully close the rebound by turning the knob
clockwise. Fully extend the rebound shaft, pulling the
inner leg up into the outer leg.
DAMPING LEG ASSEMBLY
To Next Page