Manitou M Turbo Series - Page 83

A
A
3
3
- CHECK THE FUEL LEVEL
Place the truck on a horizontal surface with the engine stopped.
To minimise the condensation due to weather conditions, the
fuel tank should be kept full as far as possible.
- Remove the cap “1” (Fig. A3).
- Through the filler intake, fill the tank with clean Diesel fuel, fil-
tered by a rose pipe or a clean cloth which does not leave
residues.
- Replace the cap “1” (Fig. A3).
Never smoke or approach with naked lights during filling or when
the tank is open.
Never fill up with the engine running.
A
A
4
4
- TYRE PRESSURE AND WHEEL NUT TIGHTNESS
Check the tyre pressure and adjust if necessary
(see “Characteristics” section).
Check the tyres for any cuts, bulges, signs of wear, etc.
Check the tightness of the wheel nuts (see Fig. A4).
Failure to follow these instructions may cause damage
and breakage of the wheel fixing nuts, leading to accidents.
A
A
5
5
- CHECK THE TELESCOPIC BOOM SLIDE RAILS
Extend the telescopic boom completely.
Check to ensure the telescopic boom slide rails are greased prop-
erly.
If necessary, clean and grease the telescopic boom slide rails
(see B4).
WHEEL NUT TORQUE LOADING
FRONT WHEEL 550Nm
REAR WHEEL 550Nm
A4
FIG. A3
1
MHT 10120 L M
S
eries
7
3
405 ft.lb.
405 ft.lb.
INTRODUCTION TO SAFETY