Manitou Mattoc Pro Service Manual

13
MATTOC PRO SERVICE MANUAL
Using the Manitou 8mm Thin Wall
Socket, turn the compression rod
clockwise until compression rod is
disengaged from the casting threads.
Remove casting from fork. It is
recommended this be done over a drain
pan as the lower casting contains semi-
bath oil. Allow oil in casting to drain out
before continuing to next step.
4
5
6
Using a downhill tire lever or similar
tool, gently pry the dust seals out of the
casting.
CASTING REMOVAL & SERVICE

Manitou Mattoc Pro Specifications

General

Spring Type	Air
Travel	160mm
Wheel Size	27.5", 29"
Adjustments	Rebound, low-speed compression
Axle	15mm thru-axle
Steerer Tube	1.5" tapered