3 - 5
USE THE RECOMMENDED LUBRICANTS :
- For topping up, oils do not necessarily have to be miscible.
- For oil changes, MANITOU oils are perfectly suitable.
DIAGNOSTIC ANALYSIS OF OIL
In the event of a maintenance or service contract with the dealer you may be requested to provide a sample of a selected
component's oil, for diagnostic analysis.
(*) FUEL SPECIFICATION
CETANE RATING : 45 minimum
VISCOSITY : 2 - 4,5 Centistokes at 40° C
DENSITY : 0,820 - 0,860 kg/litre
SULPHUR : 0,2 % mass maximum
DISTILLATION : 85 % at 350° C
- The cetane rating is a measure of the ignition quality of a diesel fuel. A fuel with a low cetane index may cause problems
with cold starts and affect combustion.
- Viscosity is the resistance to flow. If the viscosity is outside the limits, I.C. engine performance may be affected.
-
A low density reduces the power of the I.C. engine, a high density increases the power of the I.C. engine and the exhaust fumes.
- A high sulphur content (Not usually found in europe, north america or australasia) may cause wear to the I.C. engine. If only
fuels with a high sulphur content are available, it is necessary to use a highly alkaline greasing oil in the I.C. engine or to
replace the greasing oil more frequently.
- Distillation : this indicates the mixture of different hydrocarbons in the fuel. A high ratio of light hydrocarbons can affect the
characteristics of combustion.
- Fuels for low temperatures : special winter fuels may be available for use in the I.C. engine at temperatures below 0°C.
These fuels have a lower viscosity and thus reduce the formation of paraffin in the fuel at low temperatures. The formation of
paraffin can prevent filtration of the fuel.
ORGANS TO BE LUBRICATED RECOMMENDATION PACKAGING PART NUMBER
SWIVEL PINS MANITOU Grease 1 Kg. 554 973
Multipurpose HD NLGI 2 5 Kg. 554 974
REAR AXLE OSCILLATION MANITOU Grease 1 Kg. 554 973
Multipurpose HD NLGI 2 5 Kg. 554 974
REAR AXLE
To Next Page
Loading...
Need help?
General