3 - 25
E3 - TRANSMISSION OIL
DRAIN
Place the lift truck on level ground with the I.C. engine stopped, the transmission oil still
warm.
DRAINING THE OIL
- Place a container under drain plug 1 (Fig. E3/1) and unscrew the plug.
- Disassemble the access panel 2 (Fig. E3/2).
- Remove dipstick 3 (Fig. E3/3) in order to ensure that the oil is drained properly.
Dispose the drain oil in an ecological manner.
FILLING UP THE OIL
- Refit and tighten drain plug 1 (Fig. E3/1) (Tightening torque 54 à 61 N. m).
- Fill up with oil (See chapter : LUBRICANTS AND FUEL in paragraph : 3 -
MAINTENANCE) by filler port 4 (Fig. E3/3) and refit the plug.
- Run the engine at idle speed, check the oil level (See chapter : A5 - Check the
transmission oil level in paragraph : 3 - MAINTENANCE) and any possible leaks.
- Reassemble the access panel 2 (Fig. E3/2).
E3/1
E3/2
E3/3
1
2
3
4
To Next Page
Loading...
