2-83
4 - REVERSE BUZZER ALARM
5 - BATTERY CUT-OFF
6 - DIGICODE ANTI-THEFT SYSTEM
MC 30 Turbo Série 3-E3 M 26-2 Turbo Série 3-E3 M 26-4 Turbo Série 3-E3
M 30-2 Turbo Série 3-E3 M 30-4 Turbo Série 3-E3
M 40-4 Turbo Série 3-E3 M 50-4 Turbo Série 3-E3
OPERATION
- Switch on the lift truck: LED A flashes red.
- Enter your user code followed by “VAL”: LED A goes out.
- The entry of each figure in your code is confirmed by LED A lighting up green. If you make an
error, press the “ANN” key and re-enter your code completely.
- Start the lift truck within the next 30 seconds; otherwise the anti-theft system will react and
LED A flashes red.
NOTE: You can restart the lift truck within 12 seconds of stopping it: after this time, the anti-theft
system reacts and LED A flashes red.
7 - FINTRONIC ANTI-START SYSTEM
MC 30 Turbo Série 3-E3 M 26-2 Turbo Série 3-E3 M 26-4 Turbo Série 3-E3
M 30-2 Turbo Série 3-E3 M 30-4 Turbo Série 3-E3
M 40-4 Turbo Série 3-E3 M 50-4 Turbo Série 3-E3
OPERATION
- Switch on the lift truck and set the black key A next to the antenna B (maximum 80 mm).
- Wait a few seconds for red LED C to go out before starting the lift truck.
NOTE: You can restart the lift truck within 20 seconds of stopping it: after this time, the anti-start
system reacts and LED C flashes red.
8 - ADAPTATION OF DISTRIBUTOR’S 4TH ELEMENT
ADDITIONAL ACCESSORY
- Lever A forward or backward.
9 - ADAPTATION OF BALANCING VALVE ON TILTING CIRCUIT
MC 30 Turbo Série 3-E3 M 26-2 Turbo Série 3-E3
M 26-4 Turbo Série 3-E3
M 30-2 Turbo Série 3-E3
M 30-4 Turbo Série 3-E3
M 40-4 Turbo Série 3-E3 M 50-4 Turbo Série 3-E3
MC 40 Turbo POWERSHIFT Série 3-E3 MC 50 Turbo POWERSHIFT Série 3-E3
A
A
C
B
A
5
647003 EN (03/01/2012)
To Next Page
Loading...
Need help?
General