1 - 4
INSTRUCTIONS TO THE COMPANY MANAGER
THE SITE
- Proper management of lift truck's area of travel will reduce the risk of accidents:
• Ground not unnecessarily uneven or obstructed,
• No excessive slopes,
• Pedestrian traffic controlled, etc.
THE OPERATOR
- Only qualified, authorized personnel can use the lift truck. This authorization is given in writing by the appropriate person
in the establishment with respect to the use of lift trucks and must be carried permanently by the operator.
IMPORTANT
On the basis of experience, there are a number of possible situations in which operating the lift truck is contra-indicated. Such foreseeable abnormal uses, the main
onesbeing listed below, are strictly forbidden.
- The foreseeable abnormal behavior resulting from ordinary neglect, but does not result from any wish to put the machinery to any improper use.
- The reflex reactions of a person in the event of a malfunction, incident, fault, etc. during operation of the lift truck.
- Behavior resulting from application of the “principle of least action” when performing a task.
- For certain machines, the foreseeable behavior of such persons as: apprentices, teenagers, handicapped persons, trainees tempted to drive a lift truck, operator tempted
to operate a truck to win a bet, in competition or for their own personal experience.
The person in charge of the equipment must take these criteria into account when assessing whether or not a person will make a suitable driver.
THE LIFT TRUCK
A - THE TRUCK'S SUITABILITY FOR THE JOB
- MANITOU has ensured that this lift truck is suitable for use under the standard operating conditions defined in this
operator's manual, with a STATIC TEST COEFFICIENT 1.33 and a DYNAMIC TEST COEFFICIENT OF 1, as specified in
harmonized norm EN 1726-1 for mast trucks.
- Before commissioning, the company manager must make sure that the lift truck is appropriate for the work to be done,
and perform certain tests (in accordance with current legislation).
B - ADAPTATION OF THE LIFT TRUCK TO STANDARD ENVIRONMENTAL CONDITIONS
- In addition to series equipment mounted on your lift truck, many options are available, such as: road lighting, stop lights,
revolving light, reverse lights, reverse buzzer alarm, front light, rear light, etc.
- The operator must take into account the operating conditions to define the lift truck's signaling and lighting equipment.
Contact your dealer.
- Take into account climatic and atmospheric conditions of the site of use.
• Protection against frost (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL).
• Adaptation of lubricants (ask your dealer for information).
• Do not work in refrigerated warehouses (battery life would then be 30 minutes).
IMPORTANT
For operation under average climatic conditions, i.e.: between -15 °C and +35 °C and a relative humidity less than 90%, correct levels of lubricants in all the circuits
arechecked in production.
For operation under more severe climatic conditions, before starting up, drain all circuits, then fill using suitable lubricants for the ambient temperatures.
- A lift truck operating in an area without fire extinguishing equipment must be equipped with an individual extinguisher.
There are solutions, consult your dealer.
IMPORTANT
Your lift truck is designed for outdoor use under normal atmospheric conditions and indoor use in suitably aerated and ventilated premises.
It is forbidden to use the lift truck in areas where there is a risk of fire or potential explosion (e.g. Refineries, fuel or gas depots, stores of flammable products, etc.).
Specialequipment is available for use in such areas (ask your dealer for information).
- Our trucks comply with Directive 2004/108/EC concerning electromagnetic compatibility (EMC), and with the corresponding
harmonized standard EN 12895. Their proper operation is no longer guaranteed if they are used within areas in which
the electromagnetic fields exceed the limit specified by that standard (10 V/m).
- Directive 2002/44/EC requires company managers to not expose their employees to excessive vibration doses. There is
no recognized code of measurement for comparing the machines of different manufacturers. The actual doses received
cannot therefore be measured under actual operating conditions at the user's premises.
647503 (10/05/2017)
E 418/420/425C 48V S3
To Next Page
Loading...
Need help?
General