2 - 25
5 - LIGHT SWITCH, HORN AND INDICATOR SWITCH
The switch controls the road lights and horn.
A - All lights are off, the rear direction indicators do not flash.
B - The right rear hand direction indicator flash.
C - The left rear hand direction indicator flash.
D - The sidelights (OPTION) and the rear lights are on.
E - The dipped headlights (OPTION) and the rear lights are on.
F - The main beam headlights (OPTION) and the rear lights are on.
G - Headlight signal (OPTION).
To operate the horn, press the switch.
NOTE : The positions D - E - F - G can be carried out without the ignition being on.
6 - IGNITION SWITCH
The key switch has five positions :
P - Ignition off, parking position.
O - Ignition switched off and engine stopped.
I - Ignition on.
II - Heating.
III - The engine starts, return to position I as soon as the key is released
7 - FUSES BOX
Remove the cover to replace a fuse, which is to be used as per the following
numbers :
1 - OPTION Working tail lights (10A).
OPTION Left working tail light (10A).
2 - OPTION Working head lights (10A).
OPTION Left working head light (10A).
3 - OPTION Flashing alarm light (7,5A).
4 - OPTION.Cabin lifting (10A).
5 - OPTION (10A).
6 - Rear windscreen wiper (7,5A).
NOTE : Replace a worn fuse by a new fuse of equal quality and capacity. Do not re-use a repaired fuse.
8 - ACCELERATOR PEDAL
9 - INCHING AND SERVICE BRAKE PEDAL
This pedal acts in two stages :
In the first stage during the braking clearance stroke, it acts progressively the hydrostatic transmission to do a slow
approach with all the power of the engine.
In the second stage it acts both on front wheels through a brake hydraulic system, and allows to slow down and stop the
fork lift truck.
F
D
G
C
B
A
E
1
3
5
6
4
2
To Next Page
Loading...
