Manitou MSI 50 - Cab Heater Control; Heating Ventilators; Lifting of the Cab; Lowering of the Cab

2 - 28
LIFTING OF THE CAB :
- Let the R.H. door of the cab to be half open and press on the top of the
switch 17 (Fig. E) to incline the cab forward to the maximum.
- Bring back the lever 16 (Fig. B).initial position (position B).
- Close the R.H. door.
- Engage the safety shore 18 (Fig. D) in its clip vertically under the cab.
Check that any object left in the driver’s stand cannot impede the operation.
LOWERING OF THE CAB :
- Re-position the safety shore 18 (Fig. D).
- Half open the R.H. door of the cab, press on the bottom of the switch 17
(Fig. E) to lower the cab in its initial position and be sure of the locking.
- Re-close the R.H. door.
Check that nothing or nobody can impede the lowering of the cabin.
19 - CAB HEATER CONTROL
Allows the temperature inside the cab to be adjusted.
A - With the valve closed, the blower delivers fresh air.
B - With the valve opened completely, the blower delivers warm air.
The intermediate positions allow the temperature inside the cab to be adjusted.
20 - HEATING VENTILATORS
These heating ventilators allow air ventilation to be directed inside the cab.
21 - DOOR LOOCKS
22 - CLOSING HANDLES FOR DOOR
23 - UNLOCKING HANDELS FOR OPEN DOOR
24 - ACCES HANDELS DRIVER'S CAB
E
17
A
B