3 - 39
H5 – FRONT HEADLIGHTS
ADJUSTING
RECOMMENDED SETTING
(as per standard ECE-76/756 76/761 ECE20)
Set to - 2% of the dipped beam in relation to the horizontal axis
of the headlamp.
ADJUSTING PROCEDURE
Place the unladen lift truck in the transport position and
perpendicular to a white wall on flat, level ground.
Check the tyre pressures (see: 2 - DESCRIPTION: FRONT AND REAR
TYRES).
Place the forward/reverse selector in neutral.
CALCULATING THE HEIGHT OF THE DIPPED BEAM (H2)
• h1 = Height of the dipped beam in relation to the ground.
• h2 = Height of the adjusted beam.
• l = Distance between the dipped beam and the white wall.
H6 – BATTERY FAILURE
CHANGE
IMPORTANT
Operate the battery cut-out no less than 30 seconds after having switched off the ignition with the ignition key.
Handling and servicing a battery can be dangerous, take the following precautions:
• Wear protective goggles.
• Keep the battery horizontal.
• Never smoke or work near a naked flame.
• Work in a well-ventilated area.
In the event of electrolyte being spilled onto the skin or splashed in the eyes, rinse thoroughly with cold water for
15minutes and call a doctor.
- Lift out protective casing 1.
- Change the battery 2.
1
2
+%
-%
l
h1
h2
-2%
h2 = h1 - (l x 2 / 100)
h1
647104 (13/06/2016)
MT 835 / 1135 / 1335 ST3B
To Next Page
Loading...
Need help?
General
