72 Part Number STH025 8/12
Password Entry
A password is not required, although a password can
be turned on to prevent unauthorized control setting
modification. You can use the Factory Default
Password of "1234" or enter a four digit custom pin
number of your choosing.
To turn on the password feature use the following
procedure.
1. Press the Menu button.
2. From the Main menu, use the Down arrow to
highlight setup and press the Right arrow.
3. Use the Down arrow to highlight Password ON
and press the Right arrow.
4. Press the Right arrow again with Enter Passwrd
highlighted and a cursor will flash.
5. Use the Up & Down arrows to enter the factory
password (1, 2, 3, 4). Enter the number 1 in the
flashing cursor (first digit of the factory password).
6. Press the right arrow to move to the next cell and
use the Up & Down arrows to add the number 2.
Repeat this process to add 3 & 4.
7. When the last number is entered press the
Checkmark button to save your entry.
To Next Page
Loading...
Need help?
General