3.
■
Place ready the new canister (1) filled with cleaning
agent.
■
Feed the (red) supply tube plus suction nozzle (2) into
the full canister (1) and screw it on.
■
Make sure that there are no kinks in the tube and that
the vent hole on the canister cap is unobstructed.
4.
■
Check the position of the canisters:
■
The surface on which the canisters sit must not lie
above the level at which the appliance feet meet the
appliance case.
■
The surface on which the canisters sit must not lie
more than 1 metre below this level.
■
Check that you have connected the tube to the correct
connector.
■
The cleaning agent must be attached to appliance
connector G.
(The colour red is used throughout.)
5 Cleaning procedures
User manual 117
To Next Page
Loading...
