4.
■
Leave the bottle sitting upright on the spike for about 10
seconds so that the liquid drains out completely.
■
Look to check that the fluid has drained out completely.
The single-measure dispensing bottle is made of a
transparent material so that you can see how much fluid
is left inside.
■
If necessary, squeeze the rest of the fluid out of the sin‐
gle-measure dispensing bottle while the bottle is still on
the spike.
5.
■
Then pull the bottle carefully off the spike.
■
Remove the bottle from the cooking chamber.
■
Repeat steps 2 to 5 if the software prompts you to add
more than one single-measure dispensing bottle of
cleaning agent or rinse aid.
WARNING Risk of food contamination from cleaning
agent or rinse aid
■
Take care not to get cleaning agent or rinse aid on the
work surface
■
Do not place empty single-measure dispensing bottles
on the work surface, because the cleaning agent or
rinse aid could drip down the outside
6.
Close the appliance door.
5 Cleaning procedures
User manual 119
To Next Page
Loading...
Need help?
General
