3.
Open the appliance door.
4.
Insert the core temperature probe or sous-vide sensor in
the food.
5.
Close the appliance door.
Make sure you feed the sensor cable through a suitable
point in the door: the cable must not be fed into the cook‐
ing chamber in the area around door-handle closing
mechanism; it can be fed into the cooking chamber at any
other position and clamped between the appliance door
and hygienic plug-in gasket.
Disconnecting and putting away the external core temperature probe or sous-vide sensor
1.
Open the appliance door.
2.
Take the core temperature probe or sous-vide sensor out
of the food before removing the food from the cooking
chamber.
WARNING Risk of burns from high temperatures inside
the cooking chamber on all parts that are or were inside
during cooking mode
■
Wear personal protective equipment.
■
Let the core temperature probe or sous-vide sensor
cool down outside the cooking chamber after use be‐
fore disconnecting and cleaning it.
3.
Disconnect the external core temperature probe or sous-
vide sensor from the appliance case.
4.
Close the protective cap on the connecting socket.
5.
Clean and rinse off the core temperature probe or sous-
vide sensor using a soft cloth, household detergent and
water.
6.
Once it is dry, put the core temperature probe or sous-
vide sensor away in a suitable place where it is protected
from damage and dirt.
4 Cooking procedures
User manual 80
To Next Page
Loading...
Need help?
General
