5-18 3-29-2018 Control # 610-00
OPERATING CONTROLS - AERIAL LIFT NBT40-1 SERIES OPERATOR MANUAL
SHUT DOWN AND PREPARATION FOR
ROAD TRAVEL
1. Ensure the aerial work platform is properly stowed and
secured or removed from equipment.
2. Ensure the swingaway, if so equipped, is properly
stowed and secured or removed from equipment.
3. Retract and place the boom in boom rest.
4. Ensure the center front stabilizer is fully retracted, if
equipped.
5. Ensure the outrigger beams and jacks are fully retracted
and secured with the floats properly stowed.
6. Engage the travel lock at each outrigger beam (if
equipped).
7. Engage the swing brake.
8. Engage the swing lock.
9. Ensure the A2B weight is properly secured.
10. Turn off the ignition and all other switches at the ground
control.
11. Close and/or secure all windows and doors.
12. Exit the cab, lock the door, and stow the access ladder.
13. Secure any loads or lifting devices on chassis bed or
body.
14. Ensure tires are properly inflated.
15. Disengage the Power Take Off (PTO) and start engine
from the chassis cab.
16. Release the park brake before moving equipment.
CAUTION
Disengage the hydraulic pumps for extended traveling,
cold weather starting, or engine checks.
Check cold tire pressure prior to extended travel. Refer to
tire inflation on equipment.
CAUTION
Machine Damage Hazard!
Fully retract the outrigger jacks and properly store the
floats.
DANGER
Do not travel with swingaway erected to prevent damage
to equipment.
Failure to comply with these instructions may cause death
or serious injury.
DANGER
Do not travel with aerial work platform attached to the
boom or jib to prevent damage to equipment. Failure to
comply with these instructions may cause death or
serious injury.
CAUTION
Ensure outrigger beams are retracted and secured during
travel.
To Next Page
Loading...
Need help?
General
