Manitowoc RNS012 User Manual

34 Part Number STH044 10/13
Step 6 Refer to chart and premix the correct solution
of cleaner and cool water for your model ice machine.
Step 7 Remove the top cover from the ice chute and
pour the cleaner/water solution into the evaporator.
Add the entire amount of premixed solution (excess
solution will exit through the overflow tube in the water
reservoir).
Step 8 Replace the ice chute cover and allow the ice
machine to stand for 30 minutes.
Step 9 Turn on the water supply to the ice machine.
Step 10 Move the toggle switch to the ICE position.
The compressor will energize and produce ice with the
cleaning solution.
Step 11 The ice machine will freeze and discharge
the cleaning solution into the bin. Allow the cycle to run
for 15 minutes.
Step 12 Place the toggle switch in the OFF position
and discard all ice produced during the cleaning
process.
Step 13 Turn off the water supply to the ice machine.
Step 14 Place ICE/OFF/CLEAN toggle switch in the
CLEAN position. The dump valve will open and drain
the water from the evaporator and reservoir.
Step 15 Wait approximately 30 seconds (or until the
evaporator is drained) and place the toggle switch in
the OFF position.
Step 16 Refer to chart and premix the correct
solution of sanitizer and cool water for your model ice
machine.
Model
Amount of
Cleaner
Part Number
000000084
Amount of
Water
RNS012 RNS020 2 oz (60 ml) 32 oz (1 liter)
Model
Amount of Sanitizer
Part Number
94-0565-3
Amount of Water
RNS012
RNS020
2 ounces (60 ml) 3 gallons (11.4L)

Manitowoc RNS012 Specifications

General

Brand	Manitowoc
Model	RNS012
Category	Ice Maker
Language	English