Manusa Optima+ - Commissioning; Assembly; Tools Required for the Assembly; Description of Symbols

Installation manual I Manusa
D01230EN-v4
52. Commissioning
2. Commissioning
2.1 Assembly
2.1.1 Tools required for the assembly
Drill bit: Ø3 Ø6 Ø12
Screwdriver
Drill
Spirit level
Rawlplugs S5x25
Cloth
2.1.2 Description of symbols
Read the safety instructions below very carefully, as well as the installation and operation guide before using this
product.
A
1
3
4
2
2.1.3 Identification of elements
Case: 1) Frame; 2) Front; 3) Manusa bus cable; 4) Screws.
The symbols that appear in this manual and/or on the machine are as follows:
Risk of electric shock. Do not touch the inside of the machine if you have not disconnected
the electrical supply to the machine first.
Unspecified danger. Inadequate handling can cause injuries to persons and/or damage to
the machine.
Important note. You must comply with the instructions accompanying this symbol.