Marantz CD5005 - Precautions During Service; Initializing the Unit; Service Jigs for Firmware Updates

PRECAUTIONS DURING SERVICE
Initializing This Unit
Initialize this unit if you have replaced the microcomputer, one of the parts around the microcomputer, or the CD PCB.
1. Disconnect the AC plug of this unit to turn the power off.
2. Press the "
PAUSE
" and "
OPEN/CLOSE
" buttons simultaneously while inserting the AC plug to turn the power on.
3. "
INITIALIZING
" appears on the display.
NOTE：
• Initializing the device restores settings congured by the user to the factory settings. Take note of your settings
beforehand and recongure them after initialization.
Service Jigs
The following jigs are used when updating the rmware
(RS232C → connector conversion PCB in this product + 7P cable kit).
Order the jigs from your dealer if necessary.
00DSPK-581 : WRITING KIT (without FFC) : 1
606050028012P : 7P FFC(1.0)L=240 : 1
See 27 page 「VERSION UPGRADE PROCEDURE OF FIRMWARE「.
PAUSE
OPEN/CLOSE
10