Marantz DIGITAL PM730 - Playback Operations; Record Play

LOUDNESS SWITCH
Compensates for human hearing characteristics by boosting the
bass and treble response at low volume levels to achieve a more
pleasing tonal balance. The LOUDNESS indicator lights when
this switch is pressed.
(25) BALANCE CONTROL
To adjust the level of the right and left channels. An LED lights
when the right and left channel output levels are balanced; how-
ever, it goes out if the output level of either channel is changed.
It does not affect the signal present at the TAPE MONITOR OUT
jacks.
MONO MODE SWITCH
Press this switch to place the unit in the monaural mode. (The
MONO indicator lights.)
(27) TAPE COPY SWITCHES
These switches are used for recording or dubbing with tape decks.
Pressing either of these switches selects the signals which are sent
to two tape decks. See the paragraph ““USING CASSETTE
DECKS" for further details.
HIGH FILTER SWITCH
Press this switch to eliminate noise from scratches on records or
in AM broadcasts.
(29) SUBSONIC FILTER
This filter (20 Hz) is used to reduce turntable and low frequency
noise.
FILTER INDICATOR
When the HIGH/SUBSONIC FILTER switch is pressed, the LED
lights.
(1) TONE CONTROLS (TREBLE, BASS)
These controls are used to adjust the tone. Moving either control
in the (+) direction boosts the applicable frequency range, moving
it in the (—) direction attenuates it.
TREBLE: Adjusts the level of high tones.
BASS: Adjust the level of low tones.
82) SPEAKER SWITCHES
To select the pair of speakers used. Both pairs can also be operated
simultaneously.
CAUTION: We strongly recommend that the volume be reduced
‘ before switching speaker systems to prevent damage to your
loudspeakers.
SPEAKER INDICATOR
Pressing one of the SPEAKER switches lights either the SYSTEM
1 or SYSTEM 2 LED.
PHONES JACK
Accepts headphones utilizing a standard three conductor phone
Plug (low impedance as well as high impedance units),
Plugging in the headphone cuts off output to the speakers.
SPEAKER PHASING
To assure the best stereo separation and frequency response the
speakers must be properly phased. The positive terminal on each
speaker should be connected to its respective positive terminal on
the amplifier and the negative terminal of the speakers to the
negative terminais of the amplifier.
PLAYBACK
"@ RECORD PLAY
1.
When
using
an
MM
cartridge,
press
PHONO
MM:
for
an
MC
cartridge,
press
PHONO
MC.
2. Start the turntable to play a record.
3. Adjust the volume control,
4.
Adjust
the
tone
controls
(BASS,
TREBLE)
to
suit
your
taste.
©
Be
sure
to
decrease
the
volume
when
replacing
the
cartridge
or
placing
the
stylus
on
the
disc.
©
Placing
the
turntable
close
to
speakers
may
cause
howling
at
a
high
level
of
sound
volume.
©
Do
not
apply
vibrations
to
the
turntable
during
play.
This
may
cause
the
stylus
to
jump
around
and
may
scratch
the
record.
©
Do
not
turn
the
power
off
with
the
stylus
placed
on
the
disc.
FM/AM RECEPTION
. Press the TUNER button. The TUNER LED lights.
. Tune in your desired station.
Adjust the volume control.
Adjust
the
tone
controls
(BASS,
TREBLE)
to
suit
your
taste.
SON >e
USING CASSETTE DECKS
e TAPE PLAYBACK
1.
Press
TAPE
1/VIDEO
when
the
cassette
deck
is
conrected
to
the
TAPE
1
MONITOR
terminal,
and
press
TAPE
2/EQ,
when
the
cassette
deck
is
connected
to
the
TAPE
2
MONITOR
terminal.
2.
Play
back
the
tape
on
the
cassette
deck.
3.
Adjust
the
volume
tevel
with
the
volume
control.
Notes:
1.
The
SELECTOR
switch
may
be
set
to
any
positin
when
Playing
back
tapes.
2.
When
TAPE
MONITOR
switches
1
and
2
are
presse]
simul-
taneously,
tape
deck
1
has
priority
over
tape
deck
2.
e RECORDING
Use
the
following
procedures
to
record
programs
from
sources
such
as
the
player
or
tuner.
1.
Press
either
the
PHONO,
TUNER
or
TV/AUX
RECSELEC-
TOR
switch
to
select
the
source
to
be
recorded.
(Se
Notes
1
and
2.)
2, Play the program source.
3.
Record
the
program
source
with
the
cassette
deck.
Notes:
1,
When
the
DIRECT
switch
of
the
REC
SELECTOR
ispr
essed,
the
signal
selected
by
the
SELECTOR
switch
is
recordej,
2.
When
the
PHONO
switch
of
the
REC
SELECTOR
is
pressed,
Press
either
PHONO
MM
or
PHONO
MC
of
the
INFU-T
SE-
LECTOR
(depending
on
the
type
of
cartridge
used).