Inputting characters
On this unit, you can change the name displayed on the following screens to the names that you prefer.
0
Friendly Name (v p. 85)
0
Character input for the network functions (v p. 32)
Using the number buttons
1
Display the screen for inputting characters.
0
To change a character, use op to align the cursor with the
character that you want to change.
2
Press +10 to select the character type (upper case,
lower case, or numeric characters).
3
Press 0 – 9, +10 until the desired character is
displayed.
0
The types of characters that can be input are as shown below.
.
( )
1 . @ - _ / : m n o M N O 6
a b c A B C 2 p q r s P Q R S 7
d e f D E F 3 t u v T U V 8
g h i G H I 4 w x y z W X Y Z 9
j k l J K L 5
0
z + , ; < =
> ? [ \ ] ^ ` { | }
% & ‘ ( )
! “ # $
Space
4
Repeat steps 2 and 3 to change the name then press
ENTER to register it.
Contents Connections Playback Settings Tips Appendix
75
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
