Marantz NR1200 - Remote lock function

Remote lock function
When connecting an IR receiver, enable the Remote lock function. When
the function is enabled, you can not perform operations with the remote
control unit.
By default, this function is disabled.
.
X
ZONE2 SOURCE TUNER PRESET CH +
DIMMER
TUNER PRESET CH -
STATUS
Disabling the sensor function of the
remote control unit
1
Press
X while you press and hold TUNER PRESET CH
+ and DIMMER with the unit in standby mode.
2
Use ZONE2 SOURCE or TUNER PRESET CH – to select
“RC LOCK On”.
3
Press STATUS to enter the setting.
The infrared light receiving function is disabled.
Enabling the remote sensor function
1
Press
X while you press and hold TUNER PRESET CH
+ and DIMMER with the unit in standby mode.
2
Press ZONE2 SOURCE or TUNER PRESET CH – to
select “RC LOCK
zOff”.
(z The currently set mode.)
3
Press STATUS to enter the setting.
Infrared light receiving function on the main unit is enabled.
Contents Connections Playback Settings Tips Appendix
103
Front panel Display Rear panel Remote Index