Marantz NR1603 - Specifications

152
Specifications
n Audio section
•Power amplifier
Rated output: Front:
50 W + 50 W (8 Ω, 20 Hz – 20 kHz with 0.08 % T.H.D.)
Center:
50 W (8 Ω, 20 Hz – 20 kHz with 0.08 % T.H.D.)
Surround:
50 W + 50 W (8 Ω, 20 Hz – 20 kHz with 0.08 % T.H.D.)
Surround back:
50 W + 50 W (8 Ω, 20 Hz – 20 kHz with 0.08 % T.H.D.)
Maximum effective output power: Front:
80 W + 80 W (6 Ω, 1 kHz with 10 % T.H.D.)
Center:
80 W (6 Ω, 1 kHz with 10 % T.H.D.)
Surround:
80 W + 80 W (6 Ω, 1 kHz with 10 % T.H.D.)
Surround back:
80 W + 80 W (6 Ω, 1 kHz with 10 % T.H.D.)
Output connectors: 6 – 8 Ω
•Analog
Input sensitivity/Input impedance: 130 mV/47 kΩ
Frequency response: 10 Hz – 100 kHz — +1, –3 dB (DIRECT mode)
S/N: 98 dB (IHF–A weighted, DIRECT mode)
n Video section
•Standard video connectors
Input/output level and impedance: 1 Vp-p, 75 Ω
Frequency response: 5 Hz – 10 MHz — 0, –3 dB
•Color component video connector
Input/output level and impedance: Y (brightness) signal — 1 Vp-p, 75 Ω
P
B / CB signal — 0.7 Vp-p, 75 Ω
P
R / CR signal — 0.7 Vp-p, 75 Ω
Frequency response: 5 Hz – 60 MHz — 0, –3 dB
n Tuner section [FM]
(Note: μV at 75 Ω, 0 dBf = 1 x 10
–15
W)
Receiving Range: 87.5 MHz – 107.9 MHz
Usable Sensitivity: 1.2 μV (12.8 dBf)
50 dB Quieting Sensitivity: MONO 2.8 μV (20.2 dBf)
S/N : MONO 70 dB (IHF–A weighted, DIRECT mode)
STEREO 67 dB (IHF–A weighted, DIRECT mode)
Total harmonic Distortion: MONO 0.7 % (1 kHz)
STEREO 1.0 % (1 kHz)
n General
Power supply: AC 120 V, 60 Hz
Power consumption:
Power consumption in standby mode:
Power consumption in CEC standby
mode:
Power comsumption in network
standby mode:
220 W
0.2 W
0.5 W
2.7 W
For purposes of improvement, specifications and design are subject to change without notice.
Basic version
Advanced version
InformationsInformations
DVD