Marantz SR6001 - REMOTE CONTROL OPERATION

SR6001 RS-232C Control Specification Page: 12 / 19
Document Version [1.00]
Company Restricted
Command Reply from Slave
TOGGLE “NGT:0”
OFF “NGT:1”
NIGHT MODE
ON “NGT:2”
“NGT:0” (invalid)
“NGT:1” (OFF)
“NGT:2” (ON)
VALUE
“LIP:0xxx”
(xxx = value ms)
UP “LIP:1” (up 10ms)
Lip Sync.
DOWN “LIP:2” (down 10ms)
“LIP:xxx” (xxx = value ms)
xxx = “000” (OFF)
xxx = “010” ~ “200” (ON)
TOGGLE “TTO:0”
OFF “TTO:1”
ON “TTO:2”
NEXT “TTO:3”
Test Ton e
(Force
start/stop Test
Tone with Auto
mode)
PREV “TTO:4”
“TTO:1xy” (OFF)
“TTO:2xy” (ON)
(x: Auto=0, Manual=1)
(y=Ch.)
5-1-4. Tuner contents
Command Reply from Slave
VALUE
“TFQ:0xxxxx“
(xxxxx = freq.)
UP “TFQ:1“
DOWN “TFQ:2“
Auto-UP “TFQ:3“
Tuner1
Frequency
Auto-DOWN “TFQ:4“
“TFQ:xxxxx” (xxxxx = Frequency)
if ( xxxxx < 00256 ), band = XM;
else if (xxxxx < 02000), band=AM;
else band=FM;
(ex.“08750” = FM87.50MHz)
*Auto-UP/DOWN dose not operate in XM
*XM can be selected When Band is XM.
VALUE “TPR:0ww”
UP “TPR:1”
DOWN “TPR:2”
P-Scan start “TPR:3”
Tuner1 Preset
P-Scan stop “TPR:4”
“TPR:ww”
(ww = current preset nr.)
(ww = 01 ~ ??)
TOGGLE “TMD:0”
OFF(MONO) “TMD:1”
Tuner1 mode
ON(AUTO) “TMD:2”
“TMD:0”( - )
“TMD:1” (MONO)
“TMD:2” (AUTO)
TOGGLE “TPI:0”
OFF “TPI:1”
Tuner Preset
Info.
ON “TPI:2”
“TPI:1” (OFF)
“TPI:2” (ON)
Tuner1 MEMO - “MEM:0” ACK
Tuner1 CLEAR - “CLR:0” ACK
5-1-5. XM Contents
Command Reply from Slave
TOGGLE “XDP:0”
NORMAL “XDP:1”
ART/SNG “XDP:2”
CATEGORY “XDP:3”
XM DispMode
STATUS “XDP:4”
“XDP:1”(NORMAL)
“XDP:2”(ART/SNG)
“XDP:3”(CATEGORY)
“XDP:4”(STATUS)
TOGGLE “CAT:0”
CH. UP “CAT:1”
CH. DOWN “CAT:2”
CAT. NEXT “CAT:3”
XM Category
CAT. PREV “CAT:4”
“CAT:yxx”
(y: Un search=1, in search=2)
(xx: Category No. 00(none), 01 to 32)