Marantz SR6010 - Connecting an External Control Device

Connecting an external control device
REMOTE CONTROL jacks
o
Performing operations by RC on this unit
without visual contact
You can connect an external IR receiver to the REMOTE
CONTROL connectors to perform operations on this unit with the
supplied remote control unit without visual contact. This might be
necessary if the unit is hidden in a cupboard or corner, so you can’t
directly point with the remote control unit to the device.
To do this, disable the remote control signal receiving function
(“Remote lock function” (v p. 162)).
.
RC OUT
IR receiver
NOTE
0
When the remote control signal receiving function is disabled, you can not perform
operations with the remote control unit.
o
Remotely connecting Marantz devices
When you are using a Marantz device other than this unit that
supports remote connection, you can transmit remote control
signals just by connecting the device to the REMOTE CONTROL
IN/OUT connector with a monaural cable.
Set the remote control switch located on the rear panel of the
connected audio component to “EXTERNAL” or “EXT.” to use this
feature.
.
Contents
Connections Playback Settings Tips Appendix
77
Front panel Display Rear panel Remote Index