SR8002/SR7002 RS-232C Control Specification Page: 14 / 32
Document Version [1.00]
Company Restricted
For Analog Tuner Model
Command Reply from Slave
VALUE
“TFQ:0xxxxx“ (xxxxx = freq.)
UP
“TFQ:1“
DOWN
“TFQ:2“
Auto-UP
“TFQ:3“
Auto-DOWN “TFQ:4“
HD Auto-UP
（HD Radio Only）
“TFQ:5“
This command is available
for SR8002 only.
Tuner1 Frequency
HD Auto-DOWN
（HD Radio Only）
“TFQ:6“
This command is available
for SR8002 only.
“TFQ:xxxxx”
(xxxxx = Frequency)
if ( xxxxx < 00256 ) band =
XM;
else if (xxxxx < 02000)
band=AM;
else band=FM;
(ex.“08750” = FM87.50MHz)
*Auto-UP/DOWN dose not
operate in XM
*XM can be selected When Band
is XM.
VALUE “TPR:0ww”
UP “TPR:1”
DOWN “TPR:2”
P-Scan start “TPR:3”
Tuner1 Preset
P-Scan stop “TPR:4”
“TPR:ww”
(ww = current preset nr.)
(ww = 01 ~ ??)
TOGGLE “TMD:0”
OFF(MONO) “TMD:1”
ON(AUTO) “TMD:2”
Tuner1 mode
Digital Auto
（HD Radio Only）
“TMD:3”
This command is available
for SR8002 only.
“TMD:0”( - ),
“TMD:1” (MONO),
“TMD:2” (AUTO)
“TMD:3” (Dig AUTO)
TOGGLE “TPI:0”
OFF “TPI:1”
Tuner Preset Info.
ON “TPI:2”
“TPI:1” (OFF),
“TPI:2” (ON)
Tuner1 MEMO - “MEM:0” ACK
Tuner1 CLEAR - “CLR:0” ACK
To Next Page
Loading...
