Upgrade (Auro-3D)
o
Auro-Matic 3D Strength
Changes the level of the up-mixed channels in relation to the original
input signal.
The value ranges from 1 (no up-mixing) to 16 (Maximum level,
providing maximum effect).
1 - 16 (Default:10)
0
You can set this when the sound mode is set to Auro-3D.
0
This cannot be set if the input signal contains Auro-3D signals containing a
Height channel.
o
Speaker Select
Makes settings for the speakers outputting sound.
Floor
(Default):
Plays back without height speakers.
Floor & Height: Plays back with height speakers.
0
This can be set when the sound mode is the original sound mode.
o
Subwoofer
Turn subwoofer output on and off.
On
(Default):
The subwoofer is used.
Off: The subwoofer is not used.
0
You can set this when the sound mode is “Direct” or “Stereo” and in the menu
“Subwoofer Mode” is set to “LFE+Main”. (v
p. 242)
o
Set Defaults
The “Surround Parameter” settings are returned to the default settings.
Contents
Connections Playback Settings Tips Appendix
188
Front panel Display Rear panel Remote Index
To Next Page
Loading...
