Marantz SR8002 Service Bulletin

100 Corporate Drive Mahwah, NJ 07430
Service Bulletin
No. : MZ08-US01
Date:
March 5, 2008
_____________________________________________________________
Model:
SR4002, SR5002, SR7002, SR8002
Subject: Reset Procedure
Symptom: These units have been modified to never be powered ON by any
means once they go into standby with the standby led flickering every 125m sec.,
unless the specialized procedure (*1) described below is performed.
Solution:
*1: If the unit cannot be powered on after being plugged in again
(with the STANDBY LED flickering every 125m seconds), the power amp has
failed. The unit still can be powered on again through the following method, but it
can further damage the power amplifier. Please never let end-users perform this
procedure.
SR8002, SR7002:
______________________________________________________________________________________
CONFIDENTIALITY NOTICE:
The information contained in this document is intended for the exclusive use by MARANTZ Authorized Service Centers and their
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the MARANTZ Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility will be accepted by MARANTZ for any damage, injury or
loss resulting from the misuse of the information contained in this document.

Marantz SR8002 Specifications

General

Channels	7.1
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
Total Harmonic Distortion	0.08%
Input Sensitivity	200 mV
Signal-to-Noise Ratio	105 dB
HDMI Inputs	4
HDMI Outputs	2
Component Video Inputs	3
Component Video Outputs	1
Composite Video Inputs	5
Composite Video Outputs	2
Analog Audio Inputs	7
Phono Input	Yes
Multi-room Output	Yes
Headphone Output	Yes
AM/FM Tuner	Yes
Internet Radio	No
Network Audio Streaming	No
Bluetooth	No
Wi-Fi	No
Ethernet	No
USB Port	No
Audyssey MultEQ	Yes
Audyssey Dynamic Volume	No
Audyssey Dynamic EQ	Yes
Power Output	125 watts per channel (8 ohms, 20 Hz - 20 kHz, THD 0.08%)
Digital Audio Inputs	4 (2 Coaxial, 2 Optical)
Digital Audio Outputs	2 (1 Coaxial, 1 Optical)
Dolby Technologies	Dolby Digital, Dolby Pro Logic IIx
DTS Technologies	DTS, DTS-ES, DTS Neo:6