What to do if noise is heard during AM reception on Marantz SR8300 Stereo Receiver?
If you're hearing noise during AM reception, it might be due to interference from other electrical fields. Try changing the location where the AM indoor antenna is set up to see if that reduces the noise.
What to do if noise is heard during FM reception on Marantz Stereo Receiver?
If you're experiencing noise during FM reception, it could be due to weak radio waves from the broadcasting station. Try installing an FM outdoor antenna or using cable TV/FM to improve the signal.
What to do if control with the remote control unit fails on Marantz Stereo Receiver?
If you're having trouble with the remote control, try these steps: First, replace all the batteries with new ones. Then, try controlling the equipment from a different position. Move closer to the SR8300, and make sure there's nothing blocking the path between the remote and the receiver.
Why is my Marantz Stereo Receiver not turning on?
If your SR8300 isn't turning on, the most likely cause is that the power plug isn't properly connected. Make sure to connect the power plug securely to the outlet.
What to do if speaker not outputting any sound on Marantz Stereo Receiver?
If your speakers aren't producing any sound, make sure that headphones are not connected to the headphone jack, as speakers will not output sound when headphones are connected. Disconnect the headphones.
What to do if no sound is output from the surround back speaker on Marantz Stereo Receiver?
If there is no sound from the surround back speaker, verify the following: Ensure the surround speaker cable is properly connected. Note that if STEREO has been selected for Surround mode, no sound will be output from the surround speaker. The surround back channel is only active in THX surround EX mode, so set the receiver to THX Surround EX mode.
What to do if no sound is output from the surround speaker on Marantz SR8300 Stereo Receiver?
If you're not getting any sound from the surround speaker, here's what to check: Make sure the surround speaker cable is properly connected. If STEREO is selected for Surround mode, no sound will be output from the surround speaker, so try a different Surround mode. Also, ensure that Surround = NONE hasn't been selected in SETUP mode; if it has, correct the setting.
What to do if no sound is output from the center speaker on Marantz SR8300 Stereo Receiver?
If there's no sound coming from the center speaker, check these items: Ensure the center speaker cable is correctly connected. If STEREO is selected for Surround mode, no sound will come from the center speaker, so select another Surround mode. Also, verify that Center = NONE hasn't been selected in SETUP mode; if it has, make the correct setting.
General| Total Harmonic Distortion (THD) | 0.08% |
|---|---|
| Signal-to-Noise Ratio | 100 dB |
| Input Impedance | 47k ohms |
| Weight | 35.3 lbs |
| Type | AV Receiver |
| Channels | 7.1 |
| Input Sensitivity | 200 mV |
| Video Inputs | Composite, S-Video, Component |
| Surround Sound Formats | Dolby Pro Logic II |
To Next Page
