Marbella TX2 - Charging the Battery

18
© 2017 Ma k a T e c hnologie s G roup . A ll Righ ts Re s er v ed .
Getting Started
Installation of your TX2 F HD Digital Roadcorder
TM
Charging the battery
Use the charger to charge the battery before using it for the first time. Charge
the device by connecting front camera via the USB car charger. Use only Maka-
approved chargers, batteries, and cables. Unapproved chargers or cables can
cause the battery to explode or damage the device.
Connect the USB car charger to a charging port output that support
12V to 24V.
•  When device detects no power supply, it will automatically switch off in 5
seconds time. To turn on the device again, you will need to press on the
on/ off button to manually switch it on.
•  If the battery is completely discharged, the device cannot be turned on
immediately when the charger is connected. Allow a depleted battery to
charge for a few minutes before turning on the device.
Connecting the charger improperly may cause serious damage to the
device. Any damage caused by misuse is not covered by the warranty.
•  The device can be used while it is charging, but it may take longer to fully
charge the battery.
•  While charging, the device may heat up. This is normal and should not
affect the device’s lifespan or performance.
•  If the device is not charging properly, take the device and the charger to a
Maka Service Centre.