Marbella TX2 - Advance Setting; G-Sensor Sensitivity; TV Mode; Recording File Interval

31
© 2017 Ma k a T e c hnologie s G roup . A ll Righ ts Re s er v ed .
Getting Started
Operation of your TX2 F HD Digital Roadcorder
TM
vi. Advance Setting
a. G-Sensor
This function enable to you set the G-sensor 3axis base on
your preference mode of (off/low/Med/High). Default of low is
set for the best mode.
b. TV Mode
This function enable to you set the mode of playback from device
to TV. Default is set as 50mhz but as TX2 does not support this
function so it will not be applicable
c. Recording File Interval
This function enable to you set the Time interval (loop
recording) of the video clip recording per file. Selection of
(off/3min/5min/10min) as per to user preference. Default of
3min is set for common and best recording time.
vi. Factory Reset
This function enable user to reset the device to the factory mode
setting (Default setting).