IMPORTANT INFORMATION - 1B-190-824052R3 JUNE 2002
Specifications
Gear Case Lubricant Capacity
Gear Case Ratio Capacity
1.78:1 21 fl. oz. (625ml)
1.87:1 24-1/4 fl oz. (717ml)
2.00:1 24-1/4 fl oz. (717ml)
2.30:1 24-1/4 fl oz. (717ml)
Special Tools
Description
Part No.
Flushing Attachment 44357A2
Grease Gun
91-37299A1
Quicksilver Lubricant/Sealant
Description Part No.
Gear Lubricant -
Premium Blend
92-19007A24
Anti-Corrosion Grease 92-78376A6
2-4-C Marine Lubricant
with Teflon
92-825407A12
SAE 30W Motor Oil Obtain Locally
Inspection and Maintenance
Schedule
Before Each Use
1. Check that lanyard stop switch stops the engine.
2. Visually inspect the fuel system for deterioration
or leaks.
3. Check outboard for tightness on transom.
4. Check steering system for binding or loose com-
ponents.
5. Visually check steering link rod fasteners for
proper tightness.
6. Check propeller blades for damage.
After Each Use
1. Flush out the outboard cooling system if operat-
ing in salt or polluted water.
2. Wash off all salt deposits and flush out the ex-
haust outlet of the propeller and gear case with
fresh water if operating in salt water.
Every 100 Hours of Use or Once
yearly, Whichever occurs first
1. Lubricate all lubrication points. Lubricate more
frequently when used in salt water.
2. Inspect and clean spark plugs.
3. Check engine fuel filter for contaminants – Car-
buretor models.
4. Replace Water separating fuel filter – EFI mod-
els.
5. Check corrosion control anodes. Check more fre-
quently when used in salt water.
6. Drain and replace gear case lubricant.
7. Lubricate splines on the drive shaft.
∗
8. Check power trim fluid.
9. Inspect battery.
10. Adjust carburetors (if required).
∗
11. Check engine timing setup.∗
12. Check control cable adjustments.∗
13. Remove engine deposits with Quicksilver Power
Tune Engine Cleaner.
To Next Page
Loading...
Need help?
General
