Mark Levinson 502 - Page 52

3-22
Customizing the Nº502 Mark Levinson
If the calibration reports any of these errors, refer to the “Automatic
Calibration Errors” section of Chapter 4: Troubleshooting & Maintenance
for troubleshooting information.
18. If the Run Calibration procedure passed, then proceed to Step 19.
If the Run Calibration procedure failed, then:
D check the microphones and microphone cables for proper
connection or possible damage.
D press the  button to return to the Automatic Calibration menu.
D return to Step 11 to perform the Run Automatic Calibration
procedure again.
Continue to make adjustments and rerun the test until the calibration
results indicates that the calibration has passed. If you have problems
reaching this state, contact an authorized Mark Levinson dealer for
assistance.
19. The Automatic Calibration procedure is now complete. Exit the Setup
menu and place the Nº502 into Standby Mode. Disconnect the
microphone cables from the Nº502 rear panel connectors and put
away the microphones. Be sure to pay close attention to proper
handling of the microphones and cables.
Manual
Calibration
All Manual Calibration settings are saved with each individual Speaker
Setup. The Manual Calibration menu allows the user to configure:
• Speaker Distances - the individual speaker distance adjustments.
• Speaker Levels - the individual speaker level adjustments.
The Manual Calibration menu does not use the HSG microphone kit.
Speaker Distances
The Speaker Distances parameter allows the user to set the distance for
each individual speaker. The distance measurement is in feet or meters, as
identified by the Speaker Distance Units parameter in the User Options
menu. See the “User Options” section found later in this chapter for more
detail.
To Manually Calibrate the Speaker Distances:
1. Select Speaker Distances from the Manual Calibration Setup menu
and press Enter.
2. Select the Front Left speaker parameter and press Enter.
3. Use the  and  buttons to adjust. The speaker distance can be set
from 0 to 40 feet (0 to 12m) with 6-inch (10cm) increments.
4. Repeat Steps 2 and 3 to adjust each speaker distance.
Setup:7.2-ManualCalibration
Speaker Distances
Speaker Levels