INDUSTRIAL PRINTER QUICK START GUIDE
10
3. Carefully unwind 2.5ft (75cm) of material from the spool, then re-apply the tape to keep the rest of
the material from unspooling.
Note: To avoid bending the material, tape it to the inside of the spool wall.
4. Use wire cutters or a similar tool to trim o any lament that appears bent, as it may be dicult to
load.
5. Feed the cut end of the material through the ber load tube until it reaches the ber extruder.
6. Run theLoad Fiberroutine by selectingMenu>Materials>Load Fiber > Meter Loadon your
printer’s touchscreen. Input the type of ber that you are loading and select 50cc Full or 150cc
Full, depending on the spool size. Follow the onscreen instructions to load ber. As the ber
is loading, follow steps 7 and 8 below to place your ber spool on the spindle without letting it
unravel.
7. As the ber feeds through the ber extruder, put the ber spool on the spindle such that material
exits from the bottom of the spool. Place the magnetic cap on the spindle to keep the spool in
place.
To Next Page
Loading...
