19
Japan
当該機器には電波法に基づく、技術基準適合証
明等を受けた特定無線設備を装着している。
This equipment contains specied radio equipment
that has been certied to the Technical Regulation
Conformity Certication under the Radio Law.
The WGM160P22A is certied in Japan with number
005-102265.
Canada
ISED COMPLIANCE STATEMENT:
Statement acc. RSS Gen Issue 5:
„This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including
interference that may cause undesired operation of
the device.
Cet appareil contient des émetteurs / récepteurs
exemptés de licence conformes aux RSS (RSS)
d‘Innovation, Sciences et Développement économique
Canada. Le fonctionnement est soumis aux deux con-
ditions suivantes:(1) Cet appareil ne doit pas causer
d‘interférences(2) Cet appareil doit accepter toutes les
interférences, y compris celles susceptibles de provo-
quer un fonctionnement indésirable de l‘appareil.“
CAN ICES-003(B) / NMB-003(B)
Contains IC ID 29966-WGM160P
Australia / New Zealand
Regulatory Compliance Mark
(RCM). Mandatory approval mark
for Telecom, Electrical and
Wireless products.
Compliance
EU / Europa
Märklin hereby declares that this product
is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU and
all other EU directive requirements.
Märklin hereby declares that this product
is in compliance with Radio Equipments Regulations
2017 (S.I. 2017/1206)
USA
FCC compliance statement:
„This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.“
FCC ID: 2A53260667 for MS WLAN
Contains: FCC ID 2A532WGM160P
User Information
„Changes or modications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Class B Device Notice:
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equip ment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular in stallation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the in-
terference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and receiver
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV
technician for help
To Next Page
Loading...