marposs Quick Digit - Appendix; Minimising Battery Use in Quick SPC

CHAPTER 5
25/10/17
Quick Digit
TM
Bluetooth
®
Driver
25
3.6
5 APPENDIX
5.1 Minimising battery use in Quick SPC
TM
In order to optimise the use of Quick Digit
TM
Bluetooth
®
with Quick SPC
TM
the correct
programming should be similar to the following:
1) Quick Digit
TM
Bluetooth
®
programmed to “On Request Acquisition”: in this way,
it is the Quick SPC
TM
START CYCLE that generates the request for the value
from the Quick Digit
TM
Bluetooth
®
;
• Measuring in Manual mode disabled;
• Standby Timeout set to minimum programmable value (1 minute);
• STATIC AUTOMATIC measurement step in Quick SPC
TM
with number of
acquisitions (Acquisition samples) =1.
In this way, when the START CYCLE begins the value displayed by the
Quick Digit
TM
Bluetooth
®
is acquired and used in the measurement
formulas.
If it is necessary to modify the measurement in Quick SPC
TM
Online, the
step must be programmed as static manual.
2) Quick Digit
TM
Bluetooth
®
programmed to “Continuous Acquisition”: in this way,
it is the Quick SPC
TM
START CYCLE that generates the request for the value
from the Quick Digit
TM
Bluetooth
®
;
• STATIC MANUAL measurement step, in this way the measurement is
acquired repeatedly until the STOP STEP.