LEGAL
NOTICE
Design
of
device and packaging are intellectual proper-
ties
of
Zound Industries International
AB
and Marshall
Amplification Pie. e All Rights Reserved Zound
Industries International
AB
1s
hereinafter referred to
as
"Zound Industries" or "manufacturer·
MARSHALL, Marshall Amps, their respective logos,
"Marshall" and "Marshall" trade dress are trademarks
and intellectual property
of
Marshall Amplification Pie
and may not be used without permission. Permission
granted to Zound Industries International AB.
Qualcomm aptX is a product
of
Qualcomm Technol-
ogies International, Ltd. Qualcomm
1s
a trademark
of
Qualc
omm
Incorporated, registered in t
he
United
States and other countries, used with permission.
aptX
1s
a trademark
of
Qualcomm Technologies
International, Ltd . registered in the United States and
other countries, used with permission.
The Bluetooth® wordmark and logos are registered
trademarks owned by the Bluetooth SIG. Inc. and any
use
of
such marks by Zound Industries is under license
All other trademarks are the property
of
their respective
owners and
may
not be used without permission.
For more legal information related to this product and
to its use in your specific region, and
for
more detailed
information about Zound Industries and partner &
license information. please visit the website www
marshallheadphones.com
The
user
1s
recommended
to
visit the Website regularly
for up-to-date information.
Zound Industries International
AB
, Centralplan
15
,
111
20
Stockholm, Sweden
CAUTION
/
AVIS
ATTENTION
:
RISQUE
DE
CHO
C E
LEC
TRIQUE
-NE
PAS
OUVRIR
This lightning flash with arrowhead symbol within
an
equilateral triangle
is
intended to alert the
user
to
the presence
of
non-insulated "dangerous voltage·
within the product's enclosure that
may
be
of
sufficient
magnitude to constitute a risk
of
electric shock.
Le symbole representant un eclair avec une fleche dans
un triangle equilateral a pour but d'avertir l'utilisateur
de
la
presence
de
« tension dangereuse » non-isolee
a l'interieur
du
produit qui peut etre suffisamment
1mportante pour const1tuer un risque d'electrocution.
Warning. To reduce the risk
of
electric shock.
do
not
remove cover (or back) as there are
no
user-service-
able parts inside Refer servicing to qualified personnel.
Avertissement . Afin de reduire le risque d'electrocu-
tion, ne pas retirer la protection (ou
le
panneau amere),
car
aucune piece interieure ne peut etre reparee par
l'utilisateur Confier toute reparation a un professionnel
qualifie.
The exclamation point within an equilateral triangle is
intended to alert the user
to
the presence
of
important
operating and maintenance instructions in the literature
accompanying the appliance.
004
Le point d'exclamalion contenu dans un triangle equi-
lateral, avertit l'utilisateur que la
do
cumentation fournie
avec l'appareil conlient des instructions d'utilisat1on et
d'entretien importantes
FCC
STATEMENT
Any changes
or
mod1ficat1ons to this unit not expressly
approved by the party responsible for compliance could
void the user's authority to operate
the
equipment.
This device complies with
part
15
of
the FCC Rules.
Operation is subject to the following
two
conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation. This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environ-
ment. This device must not be co-located
or
operating
in conjunction with any
other
antenna
or
transmitter.
To
comply with FCC's RF radiation exposure limits for
general population/uncontrolled exposure. this device
must be installed
to
provide a separation distance
of
at
least 20 cm from all persons.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15
of
the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation This equipment
generates, uses and can radiate radio frequency ener-
gy
and,
if
not installed and used in accordance with the
instructions, may cause harmful interference
to
radio
communications. However, there
is
no
guarantee that
interference will not occur in a particular installation.
If
this equipment does cause harmful interference to
radio
or
television reception, which c
an
be determined
by
turning the equipment off and on, the
user
is
encouraged to
try
to
correct the interference by one
or
more
of
the following measures:
Reorient
or
relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet
on
a
circuit different from that to which the receiver
is
connected.
Consult the dealer or an experienced radio/TV
technician for help
To Next Page
Loading...
Need help?
General
