Marshall Electronics CV612HT-4K - Descriptions of Major Functions; Switching to CV612 HT-4 K; Setting the Digital Output (RGB, YUV); Enabling the Tally Mode Function

Marshall Electronics 26
Descriptions of Major Functions
6.1 Switching to CV612HT-4K
1. Press [Camera 1 ~ 3] on the remote control to select CV612HT-4K.
 Camera 1 ~ 3 is selected with IR SELECT.
6.2 Setting the Digital Output (RGB, YUV)
1. Press [MENU] to activate the setting menu.
2. Press [] or [] to select [System].
3. Press [ENTER] to activate.
4. Press [] or [] to select [Digital Output].
5. Press [ENTER] to activate.
6. Press [] or [] to select [YUV / RGB].
7. Press [MENU] to exit.
6.3 Enabling the Tally Mode function
1. Press [MENU] to activate the setting menu.
2. Press [] or [] to select [System].
3. Press [ENTER] to activate.
4. Press [] or [] to select [Tally Mode].
5. Press [ENTER] to activate.
6. Press [] or [] to select [Low / High / Off].
7. Press [MENU] to exit.
6.4 Hiding the preset image switch (Motionless Preset)
1. Press [MENU] to activate the setting menu.
2. Press [] or [] to select [System].
3. Press [ENTER] to activate.
4. Press [] or [] to select [Motionless Preset].