Marshall Electronics CV612HT-4K - Saving the Current Lens Position Data; Clearing the Saved Position Data; Turning on the Back Light Compensation Function; Adjusting the Shooting Angle of the Lens

Marshall Electronics 27
5. Press [ENTER] to activate.
6. Press [] or [] to select [Off / On].
7. Press [MENU] to exit.
6.5 Saving the current lens position data
8. Press [Preset + ID] on the remote control to save the current position data.
 ID shall be a digit [0 ~ 9].
 Use VISCA command to store position data to [0 ~ 127]
6.6 Clearing the saved position data
1. Press [Reset + ID] on the remote control to clear the given position data.
 ID shall be a digit [0 ~ 9].
 Use VISCA command to clear position data stored in [0 ~ 127]
6.7 Turning on the back light compensation function
1. Press [Back Light] on the remote control to turn on or turn off the back light
compensation
[Note] Enabled only when the Exposure Mode is set to Full Auto.
6.8 Adjusting the shooting angle of the lens
1. Press [Tilt ] or [Tilt ] on the remote control to adjust the angle upward or
downward.
2. Press [Pan ] or [Pan ] on the remote control to adjust the angle to right or
left.
3. Press [Pan - Tilt Reset] on the remote control to reset the angle to the center
point.
6.9 Zooming in/out images
6.9.1 Adjust image size
1. Press [Fast +] on the remote control to zoom in images.
2. Press [Fast -] on the remote control to zoom out images.
6.9.2 Fine-tune image size