Current Time
Current date & time: Enter a new date and time and press the "Set Current Time" button to update
the date & time.
Time Format
Changes the time format. Selectable time formats are as shown below.
- YYYY/MM/DD hh:mm:ss (Ex. 2010- 4-11 18:18:42)
- DD/MM/YYYY hh:mm:ss (Ex.11- 4-2010 18:18:42)
- MM/DD/YYYY hh:mm:ss (Ex. 4-11-2010 18:18:42)
Time Zone
Select time zone of where the system is installed. Depending on the time zone, Daylight Saving
Time will work automatically.
The current time will be displayed on remote software and recording files according to the
selected time zone, not the time set on your computer.
Automatically synchronize with NTP server
Synchronizes the system time with an NTP server using NTP (network time protocol).
The name of the NTP server should be registered on the NTP server Name.
Reboot
Reboot Server
Pressing the Reboot Server button will cause the system to reboot.
Do not press the Reboot button unless the server needs a reboot.
Factory Reset
Factory Reset
This sets all settings to the factory default values. System log and user registrations are also cleared.
A time zone is a region of the earth that has uniform standard time, usually referred to as the local
time. By convention, time zones compute their local time as an offset from UTC (Coordinated
Universal Time). In casual use, GMT (Greenwich Mean Time) can be considered equivalent to UTC.
Local time is UTC plus the current time zone offset for the considered location.
The Network Time Protocol (NTP) is a protocol for synchronizing the clocks of computer
systems over packet-switched, variable-latency data networks. It is designed particularly to
resist the effects of variable latency by using a jitter buffer.
To Next Page