What to do if Martin Light Fixture is completely dead?
If your Martin Light Fixture is completely dead, there could be a few reasons. First, ensure the power is switched on and all cables are securely plugged in. If that doesn't work, check the primary fuse and replace it if it's blown. Lastly, inspect the secondary fuses located on the PCB inside the base and replace any that are blown.
Why does my Martin MAC 250 Krypton lamp cut out intermittently?
If the lamp in your Martin Light Fixture cuts out intermittently, it could be overheating. Allow the fixture to cool down, clean the fan, and ensure that the air vents at the control panel and front lens are not blocked. Improving air conditioning in the room can also help. Another cause might be incorrect power supply settings. Disconnect the fixture and check if the settings match your local AC voltage and frequency, correcting them if necessary.
What to do if Martin Light Fixtures reset but respond erratically to the controller?
If your Martin Light Fixtures reset correctly but respond erratically or not at all to the controller, first ensure that the controller is properly connected. If the issue persists, the XLR pin-out of the controller might not match the pin-out of the first fixture. In this case, install a phase-reversing cable between the controller and the first fixture.
What to do if Martin Light Fixtures reset but some respond erratically to the controller?
If your Martin Light Fixtures reset correctly, but some respond erratically, you may have poor data quality. Inspect connections and cables, correcting poor connections and repairing or replacing damaged cables. Ensure the data link is terminated with a 120 termination plug in the output jack of the last fixture. Check the address settings and bypass one fixture at a time to see if normal operation is regained. Additionally, a phase-reversing cable might be needed between the fixtures, or you may need to swap pins 2 and 3 in the fixture that behaves erratically.
General| Type | Moving Head |
|---|---|
| Pan Range | 540° |
| Control Protocol | DMX512 |
| DMX Channels | 16 |
| Prism | No |
| Control | DMX512 |
| Dimmer | 0-100% |
| Light Source | 250 W discharge lamp |
| Color Wheel | 7 colors + white |
| Colors | 7 colors + white |
| Gobos | 7 rotating gobos + open |
To Next Page
