16 MAC Encore™ Performance Safety and Installation Manual
4. See Figure 12. Loosen the four Torx 20 screws D (arrowed) to release the multi-module, then lift the
module out of the head and place it on a work surface as shown in Figure 12.
5. Use the steps above as a guide when reinstalling the multi-module. Check that you do not trap any wires
during reinstallation.
Do not disassemble the multi-module itself without service documentation or assistance from Martin®
Service.
Cleaning
Regular cleaning is very important for fixture life and performance. Buildup of dust, dirt, smoke particles, fog
fluid residues, etc. degrades the fixture’s light output and cooling ability.
Cleaning schedules for lighting fixtures vary greatly depending on the operating environment. It is therefore
impossible to specify precise cleaning intervals for the MAC Encore™ Performance. Cooling fans suck in
airborne dust and smoke particles, and in extreme cases fixtures may require cleaning after surprisingly few
hours of operation. Environmental factors that may result in a need for frequent cleaning include:
• Use of smoke or fog machines.
• High airflow rates (near air conditioning vents, for example).
• Presence of cigarette smoke.
• Airborne dust (from stage effects, building structures and fittings or the natural environment at outdoor
events, for example).
If one or more of these factors is present, inspect fixtures within their first few hours of operation to see
whether cleaning is necessary. Check again at frequent intervals. This procedure will allow you to assess
cleaning requirements in your particular situation. If in doubt, consult your Martin® dealer about a suitable
maintenance schedule.
To Next Page
Loading...
Need help?
General
