What does StE message mean on Martin Lighting Equipment?
If your Martin Lighting Equipment displays an StE (memory error) message, the user settings cannot be read from memory and requires attention from a service technician.
What does PAE message mean on Martin MiniMAC Wash Lighting Equipment?
If your Martin Lighting Equipment displays a PAE (pan error time-out) message, this indicates a pan reset switch malfunction and requires attention from a service technician.
What does TIE message mean on Martin MiniMAC Wash Lighting Equipment?
If your Martin Lighting Equipment displays a TIE (tilt error time-out) message, this indicates a tilt reset switch malfunction and requires attention from a service technician.
Why does the lamp in my Martin Lighting Equipment cut out or burn out quickly?
If your Martin Lighting Equipment lamp cuts out or burns out quickly, the fixture may be overheating. Allow it to cool down. Also, verify that the power supply setting is correct.
Why is there no light in my Martin Lighting Equipment?
If your Martin Lighting Equipment has no light, the lamp may be missing or blown. Disconnect the fixture and replace the lamp.
What to do if Martin Lighting Equipment fixture does not reset?
If your Martin Lighting Equipment fixture does not reset, it may require adjustment by a service technician.
What to do if Martin MiniMAC Wash fixture resets but doesn't respond to controller?
If your Martin Lighting Equipment fixture resets but doesn't respond correctly to the controller, consider these potential causes: 1. The controller might not be properly connected. Ensure it's securely connected. 2. The fixture addressing might be incorrect. Verify the address and mode settings on both the fixture and the controller. 3. The controller pin-out might not match the fixture pin-out. Try inserting a swapper cable in the data input. 4. There might be a bad data link connection. Inspect the cables and correct any poor connections or broken cables. 5. The data link might not be terminated. Insert a termination plug in the output of the last fixture. 6. There may be a defective fixture or two devices transmitting on the link. Bypass fixtures one at a time until normal opera...
General| Brand | Martin |
|---|---|
| Model | MiniMAC Wash |
| Category | Lighting Equipment |
| Language | English |
To Next Page