Why does Martin Light Fixture light output cut out?
If a Martin Light Fixture experiences intermittent light output cuts, it may be overheating. Allow the fixture to cool down, clean it, and reduce the ambient temperature to prevent future occurrences.
How to troubleshoot a completely dead Martin Light Fixture?
If one or more of your Martin Light Fixtures are completely dead, first check that the power is switched on and the cables are plugged in. If the issue persists, there may be a blown fuse or an internal fault. In this case, contact Martin™ Service or an authorized service partner. Do not attempt to remove any covers, replace the fuse, or carry out any repairs unless you have authorization from Martin™ and official Martin™ service documentation.
General| Brand | Martin |
|---|---|
| Model | MAC Quantum Wash |
| Category | Lighting Equipment |
| Language | English |
Settings for DMX address, ID, DMX modes, and personality adjustments.
Calibrates pan, tilt, and zoom using DMX control channel.
Tools for technicians: error list, fan cleaning, PT feedback, adjustment.
Step-by-step guide for firmware update via USB stick.
Guide for firmware update using PC and DMX interface.
Procedure to adjust pan/tilt after updating to firmware v2.0.0.
DMX channel assignments for basic control of fixture functions.
DMX channel assignments for advanced control and effects.
Indicates present problems affecting fixture operation.
To Next Page
