Martin MAC Aura - User Manual

Questions and Answers

N
Nicholas ColeJul 26, 2025
Why does Martin MAC Aura light output shut down unexpectedly?
- N
  Nicole RogersJul 27, 2025
  If the light output of your Martin Lighting Equipment shuts down unexpectedly, it's likely because the fixture is overheating. To resolve this: * Clean the fixture, paying special attention to the air vents. * Ensure there is free airflow around the fixture. * Verify that the ambient temperature does not exceed the maximum permitted level. * Switch to FULL cooling mode. If the problem persists after these steps, contact Martin for further advice.
D
Derek SimmonsAug 15, 2025
How to troubleshoot a completely dead Martin MAC Aura Lighting Equipment fixture?
- L
  Lauren MooreAug 15, 2025
  If your Martin Lighting Equipment fixture is completely dead, the issue is likely due to one of two reasons: * There is no power to the fixture. Check the AC mains power and connections to ensure the fixture is receiving power. * There is an internal circuit fault. In this case, you should have the fixture serviced by a Martin service technician.
N
nbrownNov 5, 2025
What to do if Martin MAC Aura Lighting Equipment responds erratically to the controller?
- V
  velezchristopherNov 5, 2025
  If your Martin Lighting Equipment fixture responds erratically or not at all to the controller, even after resetting, it may be due to several reasons: * There could be a fault on the data link. Inspect the connections and cables, correct any poor connections, and repair or replace damaged cables. * The data link may not be terminated. Insert a termination plug in the output connector of the last fixture on the link. * The fixture DMX addressing might be incorrect. Check the addressing on both the fixture and the controller, and ensure the fixture is set to the correct DMX mode. * A defective fixture could be disturbing data transmission. Bypass one fixture at a time by unplugging the XLR in and out connectors and connecting them directly together until normal operation is regaine...

Summary

Safety Information

Protection from Electric Shock

Guidelines for protecting users from electric shock when operating the fixture.

Protection from Burns and Fire

Precautions to prevent burns and fire hazards when using the fixture.

Protection from Injury

Measures to prevent injury during installation and operation.

AC Power

Power Voltage and Cables

Voltage requirements, cable specifications, and plug installation for AC power.

Relaying Power to Other Devices

Physical Installation

Mounting to Flat Surfaces and Trusses

Guidance on fastening to surfaces and mounting on trusses using clamps.

Operation and Effects

Color and FX Control

RDM Communication

Service and Maintenance

Cleaning and Service Utilities

Procedures for cleaning the fixture and using onboard service utilities.

Software Upload and Fixture Status

DMX Protocol

FX: Pre-programmed Effects

Onboard Control Menus

Troubleshooting

Specifications

Electrical and Thermal Specifications

Martin MAC Aura Specifications

General

Light Source	RGBW LED
Control Protocol	DMX, RDM
Pan Movement	540°
Power Consumption	200 W
Light Output	3850 lumens
Input Voltage	100-240 V AC, 50/60 Hz
Zoom Range	11° - 58°
Weight	5.6 kg
Width	302 mm