Martin MAC Aura User Manual

Display messages 31
Display messages
Message Appears when... What to do...
RST (Reset)
... the fixture is indexing effects at startup. Wait for reset to complete.
SRST (Serial reset) ... the fixture has received a reset command.
Wait for reset to complete. Note that
you can set PERSONALITY
→
DMX RESET to OFF to prevent
accidental DMX reset commands.
MEMORY ERROR ...the EEPROM memory cannot be read.
Reset fixture.
Contact Martin if problem persists.
MAIN TMP SEN ERR
(RDM message: Head Temp. Error)
...there is a malfunction in the temperature
sensor circuit in the main PCB in the head.
Contact Martin service for assistance.
BEAM TMP SEN ERR
(RDM message: Lamp Temp.Error)
...there is a malfunction in the Beam LED
temperature sensor circuit.
Contact Martin service for assistance.
AURA TMP SEN ERR
(RDM message: Lamp Temp.Error)
...there is a malfunction in the Aura LED
temperature sensor circuit.
Contact Martin service for assistance.
MAIN TMP CUT OFF
(RDM message: Lamp Temp. Cut
Off)
...the temperature sensor on the main PCB in
the head measures that temperature is too
high. Power to the LEDs is cut off.
Check that ambient temperature is not
too high. Check that the fixture is clean.
Check that there is free airflow around
the fixture.
Contact Martin service for assistance.
BEAM TMP CUT OFF
(RDM message: Lamp Temp. Cut
Off)
...the Beam LED temperature sensor
measures that LED temperature is too high.
Power to the LEDs is cut off.
AURA TMP CUT OFF
(RDM message: Lamp Temp. Cut
Off)
...the Aura LED temperature sensor measures
that LED temperature is too high. Power to the
LEDs is cut off.
PAN FBACK ERR
TILT FBACK ERR
...there is a malfunction in the optical pan or tilt
monitoring/feedback circuit (e.g. sensor
defective). After a time-out, pan or tilt stops in
a random position.
Reset fixture. Contact Martin service if
problem continues.
PAN SENSOR ERR
TILT SENSOR ERR
DRIVER CURR ERR
...there is a malfunction in the electrical
indexing circuit for pan, tilt or one of the
drivers. After a time-out, the fixture will
establish a mechanical stop, and continue to
work normally.
Reset fixture. Contact Martin service if
problem continues.
VOLTAGE ERR
RAM ERROR
...there is a voltage or RAM error.
Reset fixture. Contact Martin service if
problem continues.
EFFECTS TOO COLD
...the onboard thermostat measures that the
effects are too cold.
Leave fixture powered on to warm it up.
Contact Martin service if problem
continues or fixture is warm.
FAN ERROR
...there is a fan or fan driver error.
Check that fan on rear of head is free to
rotate freely.
Contact Martin service for assistance.
COLOR ERROR ...there is a driver error. Contact Martin service for assistance.
BEAM CALIB ERR
(RDM message: Color Calibration
Error 1)
AURA CALIB ERR
(RDM message: Color Calibration
Error 2)
...color calibration data for Beam or Aura
LEDs is invalid or there is a communication
error.
Contact Martin service for assistance.
Table 5: Display messages

Martin MAC Aura Specifications

General

Light Source	RGBW LED
Control Protocol	DMX, RDM
Pan Movement	540°
Power Consumption	200 W
Light Output	3850 lumens
Input Voltage	100-240 V AC, 50/60 Hz
Zoom Range	11° - 58°
Weight	5.6 kg
Width	302 mm