Maruyama BC2301RS - Starting and Stopping; Hot Restart and Engine Stop

＿
14
＿
Hot Restart
To start the engine that is already warmed up（hot restart）.
1. Pump the primer bulb until fuel can be seen owing through
the fuel return line to the fuel tank. Flowing fuel should be
almost clear, not foamy or full of bubbles.
2. Turn the choke lever to the Open
“ ” position, and set the
stop switch to the “START” (ON) position.
3. Leave the throttle trigger in the idle position and pull the
starter grip.
4. If the engine fails to start after three to four pulls, follow the
instructions in the Cold Starting Procedure section above.
If the engine fails to start after you follow the above proce-
dures, contact an authorized MARUYAMA dealer.
To Stop the Engine
1. Release the throttle trigger.
2. Slide the stop switch to “STOP” (OFF) position.
If the engine stops running before you turn the choke lever to
the Open
“ ” position:
Go ahead and open the choke, pull the starter grip with the
throttle trigger positioned at Fast-idle start position.
Stop Switch
Fast-idle
Start Lock
Fast-idle Start
Position
START(ON)
STOP(OFF)
Idle Position