What to do if my Maruyama BC2301RS Brush Cutter engine will not start?
If your Maruyama Brush Cutter engine won't start, first ensure the STOP switch is in the on position. Also, check the fuel tank and fill it if empty. If the engine still doesn't start, press the primer bulb until fuel flows through the fuel return line. If the engine is flooded, use the warm engine starting procedure.
Why does my Maruyama Brush Cutter engine lack power or stall when cutting?
If your Maruyama Brush Cutter engine lacks power or stalls when cutting, check the throttle wire and tighten it if it has come loose. Additionally, inspect the air filter and clean or replace it if it's dirty.
General| Fuel Tank Capacity | 0.6 L |
|---|---|
| Shaft Type | Straight shaft |
| Handle Type | Loop handle |
| Cooling System | Air cooled |
| Engine Type | 2-stroke, air-cooled |
Describes safety decals on the equipment for hazard identification.
Covers operator, equipment, fuel, and operating safety precautions.
Instructions for assembling the engine and drive shaft.
Procedures for installing loop or horn handles.
Connecting throttle cable and stop switch wires.
Instructions for attaching the cutting attachment guard.
Steps for securely attaching the trimmer head.
Steps for securely attaching the brushcutter blade.
How to attach the shoulder strap or harness.
Procedures for safe handling of oil and fuel.
Specifies the correct oil and fuel types for the engine.
Instructions for properly mixing petrol and oil for the engine.
Steps before starting and procedure for cold engines.
Procedures for restarting warm engines and stopping the unit.
Correct posture and grip for safe trimmer operation.
Techniques for trimming, scaling, and mowing with the trimmer head.
Correct posture and grip for safe brushcutter operation.
Safe cutting angles and proper brushcutter blade maintenance.
Cleaning and replacing the air filter for optimal performance.
Procedure for replacing the fuel filter.
Checking and replacing the spark plug for engine ignition.
Cleaning engine cooling fins to prevent overheating.
Inspecting and cleaning the spark arrester.
Lubricating the gearcase for smooth operation.
Routine cleaning and checking fasteners for proper tightness.
To Next Page
