＿
17
＿
Cutting with Trimmer Head
・The tip of the line does the cutting. The line should stay extended while cutting.
・Do not force the line into the material. Forcing the line will cause it to slap against the material, increasing
line usage and causing poor cutting results.
Trimming
Hold the bottom of the trimmer head about 5-10cm
above the ground and at an angle. Allow only the tip of
the line to make contact.
5-10cm Above
Ground
5-10cm Above
Ground
CORRECT INCORRECT
Scaling
To remove unwanted vegetation, hold the trimmer head
about 5-10cm above the ground and at an angle. Allow
the tip of the line to strike the ground cutting the vegeta-
tion off at the surface.
Mowing
Keep the line parallel to the ground and use a gentle
side-to-side motion.
5-10cm Above
Ground
To Next Page
Loading...
